Micro-fine Mist Beauty Facial Steamer , Sauna Herbal Therapy

Delivery Time:3 - 7 days
Certification:CE

 
Micro-fine Mist Beauty Facial Steamer , Sauna Herbal Therapy

What Is a Facial Steamer?

A facial steamer is a device that releases steam to achieve healthy-looking, clear skin. An easy-to-use facial steamer alternative can be created inexpensively. Skin-related problems such as redness especially are considerably lessened by the use of a facial steamer.

Procedure for installation and operation

1. Put the machine on the smooth table.

2. Place the spray pipe to the vapor’s exit.

3. Press the hot water cup upward and then screw it.

4. Fill water into the hot water cup from the hot-spraying water inlet until the water level gets close to the high limit for water filling. So it is with cool water tank.

5. Plug to power, press the switch to begin the operation.(Attention: The machine will utter alarm sound when you turn on hot spray switch if there’s no water or too much water in the hot cup.)

Attention for operation

1. Don’t place the machine upside down or tilt it when it is in operation. Don’t operate cold spraying or hot spraying when there is no water. Don’t use water to wash the machine. Change the water inside the cold water tank and the hot water tank and clean them frequently, and power plug must be unplugged before water changing and draining. Drain all the water out of the machine if it is not used for a long time.

2. In order to avoid danger, the water level must not exce4ed the hot wate4r cup’s high limit or water filling. Please don’t take down the spray pipe during the runtime.

3. Never pour the herbal medicine, essence and so on into the water tank directly. Or else it will damage the instrument.

4. Press the hot switch and cool switch for warm vapor.

Analysis of Common Failures

Vapor Steamer	Phenomenon	Source of trouble	Solution
Troubleshooting for cool vapor	There is air flow but no vapor at all.	Cool vapor doesn’t light up.	Add water to minimum water level, turn on cool switch.
Atomization slice is aging.	Replace atomization slice.
The water is too hard.	Change the water or drip minim vinegar.
Oil stain or soapsuds float on water.	Clean the water tank, drip minim vinegar.
There is vapor but no air flow at all.	Blower is damaged.	Change the blower.
The water level is too high.	Discharge some water.
The water level is too low.	Pour some more water.
Troubleshooting for hot vaporization	There are sounds but no heat.	The water is too pure.	Use tap