Wholesale Automatic Cable Coiling and Tying Machine with Heat Shrinking Film

When the machine is used continuously for more than three months, the temperature resistant wires in the contraction chamber should be inspected and replaced according to their aging degree. During machine operation, the operator's palm and other parts are not allowed to come into contact with the operating parts of the machine, especially the extremely high temperature inside the contraction chamber, which can easily cause burns. After the packaging work is completed, the heating switch should be turned off first, and the conveyor motor and fan motor should continue to run for about 10 minutes before cutting off the entire power supply.

When the machine is specified to have a three-phase 380V power supply, the zero line must be input simultaneously, which is similar to other packaging equipment in the standard three-phase four wire system, such as vacuum packaging machines. Otherwise, the machine will not function properly and it is highly likely to burn out internal electrical components. The machine must be installed horizontally, otherwise it will shorten the service life of the electric heating tube. For machines with conveyor belts, their inclined installation will cause the conveyor belt to deviate from the center.

Machines like packaging machines must be reliably grounded to protect personal safety. Each machine comes with a power cable that is connected to the power supply when it leaves the factory. The end lead of the cable has an identification symbol for the power supply and must be connected correctly. Violating regulations may cause electric shock.

The shrink packaging machine and the winding machine both consume a large amount of power, so the input power must be greater than the nominal power on the shrink machine nameplate, otherwise it is easy to burn out the circuit or electrical components.