Factory Sypplier Bitumen Roofing Felt Paper with Enhanced Weather Resistance

The leakage of asphalt glass cloth and felt mainly occurs at the through wall pipe, bolt, deformation joint, and roll joint. These special areas have poor waterproof base treatment, loose structure, and loose leveling layer closure; The edge of the additional layer of the coil is not tightly closed, and the cutting of the coil is irregular; Poor twisting and compression of the deformation joint waterproof strip, structural deformation, and other reasons cause water leakage at the deformation joint; The joint rolls constructed successively at the joint of asphalt glass cloth and asphalt felt have been damaged, and the adhesion is not tight, resulting in water leakage. During construction, standardized treatment methods should be adopted according to different special parts. During operation, the roll material should be carefully cut according to its shape, and the edges should be flattened and tightly bonded. After completing the additional layer paving in these parts, careful inspection should be carried out to ensure strict acceptance.

The reason for the occurrence of hollowing in asphalt glass cloth and felt is often due to the high moisture content of the base layer of the membrane waterproof layer. Before the leveling layer is dried, the membrane waterproof layer is constructed to seal the moisture inside, and when exposed to hot gas, the waterproof layer swells up; When laying different types of oil felt rolls, if the pressure is not tight and the adhesion is not dense, the hot air generated during the operation will be trapped, causing the rolls to bubble and bulge. During construction, attention should be paid to the dryness of the base layer. During operation, it should be compacted and tightly adhered, and no gas should be trapped to prevent hollowing.